Tennant T7 – How to Remove the Brush Heads
Video Description
This video guide from Alpha Power Cleaners shows you how to remove the brush heads on a Tennant T7 floor scrubber dryer. Knowing how to safely remove and inspect the brushes allows you to keep your machine in top working condition and replace worn brushes quickly.
In this video, you will see exactly:
- how to locate the brushes in the brush head compartment
- how to remove the safety pin and open the yellow safety clamp
- how to open the side skirt to access the brushes
- how to press the yellow clips to release and drop the brush
- how to inspect, clean or replace the brushes and refit everything correctly
Following these steps ensures your brushes are properly maintained and the machine is reassembled safely after each inspection.
If you are unsure about any part of the process – or you need servicing, repairs, parts, or technical support for your Tennant T7 – contact Alpha Power Cleaners. Our team specialises in Tennant scrubber dryers and industrial floor cleaning machines, providing expert help whenever you need it.
Video Transcript
Hi, I’m Dave from Alpha Power Cleaners and today I’m going to show you how to remove brushes on a Tennant T7.
The brushes are located in the brush head. To remove the brushes, remove the safety pin and open the yellow safety clamp. This will enable you to open the side skirt and locate the brushes.
To remove the brushes, press the two yellow clips together and the brush will drop down. Check for debris or anything in the brushes.
If new brushes are needed, put some new ones on. If not, give them a clean and then push the yellow pins back together and push the brush back into place to locate it. Close the door, the safety clip, and put the pin back into place.
